Drying and Shrinkage Heat Press Felt Blanket Heat Transfer Printing Felt

Drying and Shrinkage Heat Press Felt Blanket Heat Transfer Printing Felt

Drying and Shrinkage Felt Blanket for Sanforizing Machine is used for Drying wet fabric while shirking, denim finishing plants sanforizing, and improve the fabric. Special needle punch sanforizing blanket style with heat and chemical resistant synthetic fibres available for the most modern machines with pressurized steam.

Our main materail are Polyester, Acrylic, Wool,NOMEX.

Suporfel provide sanforising felts are used on the Palmer unit of the compressive shrinking range or Sanforising machine.

Tracing problem in Drying and Shrinkage Felt Blanket for Sanforizing Machine

It is always best to follow our Installation Instructions from the start. Otherwise, irreversible damage may occur. PLEASE do not hesitate to contact us with your questions at the start of a problem rather than after it’s potentially too late for us to help.

General Rule to remember: THE FELT ALWAYS TRAVELS TO THE SIDE WITH THE LEAST AMOUNT OF TENSION.

Keeping this rule foremost in mind will help when trying to determine, through the process of elimination, which variable(s) may be causing the felt to track improperly.

Please triple check the following:

That all rolls have been reinstalled, correctly pinned or bolted, turn freely, and are parallel to the heated cylinder.

That the pistons used to engage the tracking roll are properly working.

That the feeler gauges or tracking sensors are working properly.

That the felt is not too wide, thereby hanging over the cylinder(s) edge(s).

That there is enough heat in the main cylinder to create sufficient friction such that the felt holds to the heated cylinder as opposed to slipping against a cold cylinder (352° C / 200° F).

NOTE: We highly recommend that you take a few moments before installing a felt to measure the length (see diagram below). Please compare your figures to ours provided on the Certificate Of Analysis enclosed with the packing slip. Should a discrepancy exist, please call before installing.

FAQ:

Q1: Quality Assurance

A1: We we have strictly test according to industrial standard.

All materials and finish products are in accordance with the industrial standards.

Q2: Price and Quotation

A2: Competitive Cost price. Warmly welcome to negotiate long term cooperation.

Q3: Lead Time and Freight

A3: Our factory is located in Shanghai, very near to Shanghai port and Shanghai Airport.

General delivery time is 5-8 days after payment/.

We can make delivery by DHL,FEX,UPS,TNT etc by air.

Q4: Terms of payment

A4: T/T payment in advance.for mass production, we can do 50%TT in advance, and 50%balance will be paid before shipping