Endless Heat Transfer Printing Felt Nomex Heat Resistant Felt Custom Made

Endless Heat Transfer Printing Felt Nomex Heat Resistant Felt Custom Made

Heat Resistant Felt Nomex Endless Transfer Printing Blankets is made of imported high-temperature resistant aramid fiber, and the middle Fabric is made of seamless cylinder base fabric. The dry heat shrinkage of the door web is 2.5%, the elongation is 3%, the use temperature is below 300°C, and the conventional thickness is 8mm.

Our Heat Press Felt is made of Aramid/Nomex fiber, PES, which is available for various heat transfer printing machine.

As leading manufacturer of felts in China for over 15 years, our advantages are follows.

1. Shrinkage----The base cloth can control the shrinkage rate in 2.5%--3%.
2. Material---100%  Nomex.

Tracing problem in Heat Resistant Felt Nomex Endless Transfer Printing Blankets felt

It is always best to follow our Installation Instructions from the start. Otherwise, irreversible damage may occur. PLEASE do not hesitate to contact us with your questions at the start of a problem rather than after it’s potentially too late for us to help.

General Rule to remember: THE FELT ALWAYS TRAVELS TO THE SIDE WITH THE LEAST AMOUNT OF TENSION.

Keeping this rule foremost in mind will help when trying to determine, through the process of elimination, which variable(s) may be causing the felt to track improperly.

Please triple check the following:

That all rolls have been reinstalled, correctly pinned or bolted, turn freely, and are parallel to the heated cylinder.

That the pistons used to engage the tracking roll are properly working.

That the feeler gauges or tracking sensors are working properly.

That the felt is not too wide, thereby hanging over the cylinder(s) edge(s).

That there is enough heat in the main cylinder to create sufficient friction such that the felt holds to the heated cylinder as opposed to slipping against a cold cylinder (352° C / 200° F).

NOTE: We highly recommend that you take a few moments before installing a felt to measure the length (see diagram below). Please compare your figures to ours provided on the Certificate Of Analysis enclosed with the packing slip. Should a discrepancy exist, please call before installing.